Chaging my timing belt but

dustinshu · November 2010

the crank shaft pulley off is it reverse thread or what ha ha it is like stuck on there

:? :? :? :? :? :? :? :? :? :? :? :? :? :? :? :? :? :? :? :? :? :? :? :? :?

superhatch · November 2010

You will need a large breaker bar or air tools to get it off most likely. I think it's 132 ft/lbs torque when it was put on but you're likely having to break corrosion as well. This usually takes quite a lot of effort.

There is also a tool you can buy to do the job as well as a variety of videos and forum entries on tricks you can use to help get it off.

bikewrench · November 2010

Remove the starter and stick a big screwdriver in the fly wheel teeth. Then use a long breakerbar on the nut,its normal right hand thread.

ragenasian · November 2010

You can always try searching as well.

viewtopic.php?f=7&t=10487&p=120044&hilit=pulley#p120044

viewtopic.php?f=7&t=4407&p=80494&hilit=crank+pulley#p80494

dustinshu · December 2010

thanks i got it off now its running so good haha

Chaging my timing belt but

Comments