There's a cover below the center lower rear ashtray.pry from the side using a screw driver to remove cvr.Between 2 cables u'll c a nut.This is the adjustment nut.
To do it right.
1) Jack rear of Wagon up.(block frt.tyres)
2)Pull e-brake handle up 1 click.
3)Tighten nut till there's a slight drag on the rear wheel.
4)Done.
The check: When you normally pull the e-brake it should be 6-10 clicks.
:oops: I just do it by instincts.Basically when handle gets too hi...adjust.
Comments
remove the ebrake cover, you will see the two steel lines that clip onto the back part of the ebrake and use a screwdriver to tighten.
1) Jack rear of Wagon up.(block frt.tyres)
2)Pull e-brake handle up 1 click.
3)Tighten nut till there's a slight drag on the rear wheel.
4)Done.
The check: When you normally pull the e-brake it should be 6-10 clicks.
:oops: I just do it by instincts.Basically when handle gets too hi...adjust.