Rt4wd help!! no drive to the front at all

I have replaced the drivers side knuckle and everything went back in fine. took it for a test drive and thought the clutch was slipping but its not. turned around on some gravel and noticed the rear wheels were slipping. thought nothing of it. went for another drive and gave it more revs on the gravel and the rear wheels spun. I havent noticed any unusual clunks etc when driving from the front.

Wtf is going on here?

any ideas?

Comments

  • this happened to me on my RT. the support/bearing on the driver's side axle wasn't bolted to the engine so my axle was slipping out of the tranny.

    check to make sure the axles are in the trans.
  • rti intracrti intrac Senior Wagonist
    Drivers sider here is usdm passengers side, the inner cv is loose in teh cup, I think the pivot thingies? have come out, good to know.
  • I forgot you were in NZ, LoL!

    that could be your problem then. what was weird about mine when that happened, was I had no drive at all. I don't think my 4wd is working...?
  • rti intracrti intrac Senior Wagonist
    Yeah it is lol, I just had a look underneeth.. drive shaft flops around, Ill bring it into work tomorrow and get it done after
  • swaiteswaite New Wagonist
    Sooo what's the problem here? :P
  • rti intracrti intrac Senior Wagonist
    The bearings fell out of the inner CV when I took the driveshaft out of the knuckle
  • HaydzHaydz Moderator
    Mine did that when i did the ZC swap - i went to parts world or something in Henderson and got two front axles with good CVs.
  • rti intrac wrote:
    The bearings fell out of the inner CV when I took the driveshaft out of the knuckle

    is it working again then?
  • rti intracrti intrac Senior Wagonist
    I Have just got home from work and i'm about to hopefully get it back together
Sign In or Register to comment.