B18A1

C-ratZC-ratZ New Wagonist
in Engine & Drivetrain
hey everyone im new to this site and just picked up a 90 wagon. i bought an LS swap that came right out of a crx...(mounts, shift linkage etc.) i just put the motor in today and it sits kind of funny. im pretty sure one of the mounts are wrong. could you tell me what t bracket i need and which back motor mount i need?

edit: will lowering springs make my car sag in the rear end? ive heard this happens because the rear end is heavier but i have a 2wd so i dont know if that makes a difference. im thinking about getting some skunk2 lowering springs that have a 2.5 inch drop

Comments

  • bam-bambam-bam Council Member
    all the stuff from the CRX should fit right up...if it fit in the rex, it'll fit the wagon.
  • bam-bambam-bam Council Member
    should be the T-bracket from a manual 2g Integra
  • C-ratZC-ratZ New Wagonist
    thats what i was thinking. but i had to shift my back motor mount over to a next set of holes?
  • bam-bambam-bam Council Member
    right. You'll use the pair of holes closest to the center. I don't know if a relocated stock mount will work, both of the ones i've done used aftermarket "swap mounts".
  • C-ratZC-ratZ New Wagonist
    hmm...maybe i just have the wrong t bracket. it did look larger than normal...ill take it off tomorrow and compare it to the 94-01 integra t bracket i have
  • C-ratZC-ratZ New Wagonist
    nevermind i found out how to search lol thanks guys
Sign In or Register to comment.

© Vanilla Keystone Theme 2025