well i just pu in a newer rack and pinion. no more shakes or what so ever. car just wanders around like it needs to pee. getting alingment tom hopfully.
Just got my new headlights from ONKYO they are suppppper clean
nice... i was thinking about those too when i saw them but i didn't know about the headlight wire so i pass but now since i know... damn... good stuff lol
Painted rear bumper black to match front, chucked on some bottlecaps I brought (195/60/14 horrible) and uh got some stuff from the wreckers I need, side trim and interior bits.
Finally got my "new" muffler welded up and bolted on, can hear my self think again! Fixed the exhaust manifold heat shield rattle. Removed the other heat shields for the same reason and welded the center exhaust hanger back on.
Ordered
Timing Belt
Timing Belt Tensioner
Timing Belt Tensioner Spring
Air Conditioner Belt
Power Steering Belt
Alternator Belt
2 Driveshaft Carrier Bearings
Rear Differential Bushing
Upper Radiator Hose
PCV Valve
Distributor Cap
Distributor Rotor
Oil Filter
Air Filter
Fuel Filter
Water Pump
Oil
Honda MTF
Rear Differential Fluid
Energy Suspension Radius Rod Bushings
I still need to get Ball joints for the front suspension. Today was a very busy/expensive day
well scrapped down main drag bumping to some tunes' rinsed it got salt all over it 2 mins later and pic'ed up bottlecaps for it. then drove it to a friends were i traded them for 150 bux and set fat 5's with low pros / after all that jazz blew cyclone in local wal-mart on some snow ! weeeee and popped vtec down the drag went home.
took off the front clip and got really serious about the wire tuck and also started shaving the passengers side firewall
much work left to do but its a start
Passenger side mirror and five panel wink its time for a wash when I get off of work... I have a passenger fender mirror im willing to part with. Let me know.
New rear brakes, a good washing after sitting for almost 3 years, inspection, inside cleaning and a 400 mile roadtrip to Columbus Ohio and back.
Now all I have to do is a complete fluid change and a thorough tune-up.
I envy those who took off the seats and put the cloth back on with the clips. I'm using zip ties and it's still pretty darn difficult. Seats are looking good though.
i just replace my shoes on my EF8 and after about an hour and a few wrenches thrown gave up til tomorrow. i then proceeded the next day and it only took me only 10min.!!!! Seriously!!! my advice, invest in a honda service manual, it saves your knuckles and nerves!
by the way.............gave my drwagon some bottle caps.
Comments
nice... i was thinking about those too when i saw them but i didn't know about the headlight wire so i pass but now since i know... damn... good stuff lol
Ordered
Timing Belt
Timing Belt Tensioner
Timing Belt Tensioner Spring
Air Conditioner Belt
Power Steering Belt
Alternator Belt
2 Driveshaft Carrier Bearings
Rear Differential Bushing
Upper Radiator Hose
PCV Valve
Distributor Cap
Distributor Rotor
Oil Filter
Air Filter
Fuel Filter
Water Pump
Oil
Honda MTF
Rear Differential Fluid
Energy Suspension Radius Rod Bushings
I still need to get Ball joints for the front suspension. Today was a very busy/expensive day
much work left to do but its a start
Now all I have to do is a complete fluid change and a thorough tune-up.
Also put in the headliner, "oh shit bars" and the map lights.
Car running much smoother now and not noisy anymore! Delighted with it.
Some body work, new front lip and an outer CV Joint to sort next week.
New pads and rotors up front, 30 minutes.
New shoes out back 2 hours.
by the way.............gave my drwagon some bottle caps.