Help me!!! Violent wagovan shake!

T4D2B0T4D2B0 Band Wagon
in Engine & Drivetrain
Some please help me!! I just bought an 89 honda wagovan 4wd. While driving it home 30 min after I bought it the engine blew. We then put in a d15b7, was a d16a6, both with a z6 head. After the swap however, the car now shakes VIOLENTLY on the front passenger side it feels like. The vibration starts as soon as I accelerate and is so bad I can't go over 20mph without shaking everything out of my dash. Almost feels like I'm 4wheeling on a flat road. I have no experience with hondas and don't have time to check everything little thing. Can anyone help me PLEASE!?!?

Comments

  • civtec350civtec350 Wagonist
    did you put the bolts in holding the halfshaft to the block. its on the driver side but id imagine it would be a lot of vibration. i would make sure the axle nuts are tight and staked on both sides. also jack it up to see if there is any movement in steering and suspension components.
  • HaydzHaydz Moderator
    I reckon civtec will be right, the intermediate shaft won't be secured.
    You can only fit one of the bolts on the D15B block, not all three like a D16A or ZC.
    To get around this you run a hush performance intermediate shaft relocator.
Sign In or Register to comment.

© Vanilla Keystone Theme 2025