LS swapped wagon will only turn over

cadillac_davecadillac_dave Wagonist
in Electronics, Fueling & Air Conditioning
So here's my problem. B18a1/ys1 swapped 88 wagon. I stayed obd0. Car cranked up and ran no problems before the swap. Now I'm not getting any power to the ecu or fuel pump. Also when I press the brake pedal the temp gauge goes all the way up, the CEL light, battery light, e brake light and oil light comes on. Car will turn over but that's it.

Comments

  • NZ-DB8RNZ-DB8R Moderator
    Sounds like you havnt connected an earth or two
  • cadillac_davecadillac_dave Wagonist
    Now that Im at work, isnt there a ground around the gauge cluster? If so that might be it
  • klumklum Senior Wagonist
    yes there is and its viewable by removing the lower bezel or trim that connects to the fuse area i believe on the right side of the gauge bezel near the emergency light plug
  • cadillac_davecadillac_dave Wagonist
    Wonder if that might be my problem cause I know for sure it's not grounded lol
  • cadillac_davecadillac_dave Wagonist
    This is what I found. 238.jpg
    239.jpg
  • cadillac_davecadillac_dave Wagonist
    Now the question is, will one out of a manual wagon work? My car started off as an automatic.
  • NZ-DB8RNZ-DB8R Moderator
    Depends what it is, obviously a plug but which one?
  • cadillac_davecadillac_dave Wagonist
    Ignition switch
  • klumklum Senior Wagonist
    any one from the same year will work forsure except 88 not forsure about that try to get one that matches ur year , sedan, hatch, will work
Sign In or Register to comment.

© Vanilla Keystone Theme 2025