putting together a driveshaft with no phase marks

drfinkdrfink Wagonist
in Engine & Drivetrain
when i got my car the entire driveshaft and the vc were removed from the car, and separate. when i went to put it in i realized why; a locked up u joint in the rear which the previous owner had already taken off the flange yoke. so basically i have my driveshaft in 3 separate pieces, well 4 if you include the flange that attatches at the end, and there are no phasing marks on any of it. how would i put it back together and avoid vibrations?

is this picture correct? how do i make sure i'm not 180 degrees off when i put it back together with new u joints?


534.jpg

Comments

  • bam-bambam-bam Council Member
    Yes, the picture is correct. Don't worry about being 180 out, doesn't matter.

    Since the rear half is fixed, there's no worry about phasing anyway.
    The front half includes the viscous coupler, which slips and makes phasing irrelevant.
  • drfinkdrfink Wagonist
    thanks bam good info. this is the second time you've helped me out lol, i appreciate it
Sign In or Register to comment.

© Vanilla Keystone Theme 2025