YS1 missing cover: can anyone identify

Comments

• Chiddie New Wagonist

  January 2012

  There may not actually be a cover for this area after scouring the online Acura parts listings. If this is the case, what bolts to the 2 far right bolts on the transmission. I'm a bit stumped on this one. Thanks.
• wagonlee89 Band Wagon

  January 2012

  T bracket and the dust cover
• DREADPiRATE Band Wagon

  January 2012

  any b series flywheel dust cover will work. B20 has one for the auto trans so just go to a local junk yard and pull one off an Ls 5 spd. its steel instead of the aluminum bracketed one that the b20 comes with (auto trans).
  
  Also... If your going to get a clutch. the Ys1 is a 92-93 big spline input shaft. when you buy your clutch buy a Hydro b series clutch. Its the same. ys1 internals are just like Hydro. the only difference is the case. most people make the mistake of getting the small spline cable trans clutch. good luck!
• bam-bam Council Member

  January 2012

  http://www.acuraoemparts.com/delray/jsp ... vinsrch=no
  
  #11 in this picture. Rear engine mount bracket, known as a "T-bracket"
  
  Sorry, I'm not much good with computer stuff
• Blackout_wagon Wagonist

  January 2012

  most if not all people throw the dust cover in the garbage . . i have a few in the shop i use them as scrap . the 2 far holes are for the rear trans T-bracket that use 2 19mm head bolts . your trans looks intact and ready to mate to your B20 with no problem
• Chiddie New Wagonist

  January 2012

  Thanks all, I'm glad you let me know as I would have got half my swap done before I realized I needed that.