And I thought b series CRV swaps were awesome!
This is properly nuts! Did you end up snagging the entire CRV center driveshaft and modified it to fit the wagon's length?
And I thought b series CRV swaps were awesome!
This is properly nuts! Did you end up snagging the entire CRV center driveshaft and modified it to fit the wagon's length?
yes it has a crv rear end
the center drive shaft is going to be modified
Is there anyway to throw a limited slip in the rear diff? because that would just make this even more better
well they dont make one so that would be a tad difficult. only thing you could do is weld the spider gears if there are any. have not taken the diff apart to investigate
either way you would want one in the front more than you would the rear
Comments
thats a uniwiper. poor boy mod from 15 years ago. you take your drivers wiper and put it on the passenger side
no updates as of yet been working on a few things
new cluster so dont have to run a cable speed sensor or speedo cable
This is properly nuts! Did you end up snagging the entire CRV center driveshaft and modified it to fit the wagon's length?
yes it has a crv rear end
the center drive shaft is going to be modified
K24
its being built to take out to the desert and go romping
its no beauty queen so i dont think any magazine covers are in store
well they dont make one so that would be a tad difficult. only thing you could do is weld the spider gears if there are any. have not taken the diff apart to investigate
either way you would want one in the front more than you would the rear
Amen, brother! No desert here in Georgia, but I'm headed to the woods when I get done. Awesome job, I appreciate the engineering involved.
thanks man. good luck on your gold build. if we had woods here it would be headed there too ha ha
i'm glad i checked in today (after being gone for so long) to see this.